Updating scott 299 amplifier

A powered subwoofer, built to fit exactly in your vehicle, supplies the bass you need for fully balanced music.VSS Powerstage upgrades come with all the wiring precut and terminated to make installation easier.Step-by-step, illustrated instructions make this sonic upgrade a fun and rewarding project.This is just one way to add improved sound to your car without changing the factory stereo.Kicker's technicians measured the acoustics of the specific vehicle's interior, then developed a program to get the strongest and cleanest audio performance possible from the stock speakers.The VSS Powerstage module breathes new life into your vehicle's factory system, automatically correcting for the limitations of the factory speakers, then adding plenty of power so the speakers can sound their best. I was just listening to some music in my 2 channel system and noticed that music from the left channel is really distorted.I initially thought there was something wrong with the speaker but when I switched the speaker wires around the distortion followed to the other speaker. The music from that one channel is really garbled, scratchy and full of static.

They’re often programmed with equalization (EQ) curves that compensate for the system’s lack of power by reducing the level of the bass, for instance.WARNING: Hack RF One is test equipment for RF systems.It has not been tested for compliance with regulations governing transmission of radio signals.Luckily, this problem has some solutions that let you keep your factory stereo and get spectacular sound, customized for your specific vehicle.The two upgrade systems we discuss in this article improve the factory sound of different vehicles in different ways — you can call us if you need a hand deciding which will work best for yours.JDyou might want to use DEOXIT to clean and lubricate your terminals on the amp.If that doesn't work, internally there is probably an issue with some of the resistors.I also attempted to put to practical use the creative writing degree I had picked up along the way.In 2006, I finally came to my senses and got this job at Crutchfield where they actually pay me to ramble on, rant, and explain the things I love about music, electronics, and getting good sound.In the 1960's, I studied radio and electronics at the Franklin Institute in Philadelphia.After college, in the early 70's, I joined a rock 'n roll band as the soundman, learning how to operate the electronics that make music sound good.

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “updating scott 299 amplifier”